In this state, the Flash Tool does not close the COM port, and trying to restart any operation by reconnecting the device will cause an error. When after the red strip pass to 100% as a result of the firmware, Operation buttons are again available for clicking, but no error message, no green circle, this error appears, or similar to it, the code of which is 1013. The port was visible, it was selected in the Flash Tool settings, the program recorded it in the INI file, after which the system was rebooted with the port disabled, and immediately launched the Flash Tool without selecting the port. So you should have been installed MTK drivers before flashing. This tool only allows flash custom recovery to MediaTeck based android devices and it works devices which comes with scatter file.
#SP FLASH TOOL NOT DETECTING PHONE INSTALL#
Theoretically, it can occur in the USB UART mode. SP flash tool is an Android SmartPhone application which allows you to easily flash stock ROM and install custom ROMs on your android phone. If the USB port of the computer is faulty, then it is necessary to puncture the cable to another port.
The problem can be in the USB cable, in this case, replace the cable. In this case, you will not see the equipment on which the PRELOADER drivers are placed. Even if the COM port is virtual, and the physical USB. The tools automatically detect the phone if you have a perfect connection. Be sure you have Android debug (ADB)driver install, If you want it- Download LINK or HERE 4. For example, an error may occur if COM ports are disabled in the BIOS. Connect the Android phone to PC with ADB enable in phone setting and Rooted.
0 kommentar(er)
